Roundtable Software E-Mail Newsletter Issue #14, March 13, 2002
A: You will get this message (or a File Not Found message)
under two conditions. The first condition is that you are not running Advantage
version 3.3. If this is the case you will not be able to use the Data Export
Tool as it has been designed to work with Advantage version 3.3+.
Assuming you are on version 3.3 and your Advantage data files are current
(you can run SA7 to be sure), then the other possibility is that you specified
the incorrect directory for your Advantage AFILES/SYS files during the
installation of the Data Export Tool. When you install the Data Export
Tool it is very important that you specify the correct Advantage AFILES/SYS
directory. The setup program asks for two directories; first the directory
where you wish to install the Data Export Tool (this can be any directory
you wish), and then the SYS directory where your Advantage system data
files reside. The default shown for this question, C:\ADV\SYS, is NOT a
suggested directory – it is simply the most common directory where the
software is typically installed. The installation program DOES NOT check
your system to provide a suggested directory here. Thus, if you just leave
this prompt at the default you may very well be specifying the wrong directory
and the Data Export Tool will not work properly. If you have installed
the software improperly, you can simply re-install using the SETUP program
to correct this problem.
A: USB printers have a problem in that they do not run off ports that are ‘published’ to MS-DOS. Unlike parallel printers which get assigned DOS LPT ports, USB printers do not have port names such as USB1, USB2, etc. Because of this, DOS applications cannot directly print to a USB printer. However, you can actually print to USB printers from Advantage in one of two ways:
1) Using Fabsoft’s Reform product you can print to any printer, including USB printers. Because Fabsoft addresses printers through Windows, it can access USB printers with no trouble.
2) If you are on a network, a shared USB printer can be printed to from
DOS applications. When you share the printer just tell it to associate
that printer with an LPT port (1-9 if you are on Windows 95/98/NT/2000,
1-5 on Windows me, 1-3 on Windows XP). Once the printer is associated with
an LPT port Advantage can print to that printer simply by choosing that
printer number in Advantage. It will print to the printer just as if it
were a parallel printer.
Previous Newsletter Next Newsletter
|Roundtable Software 30831 Cove Road Tavares, FL 32778-5164
(352) 253-9779 FAX: (815) 572-5446
All contents copyright © 2000-2008 Roundtable Software. All rights reserved.